A guide to Use Drivemon to Upload/Download .Dnl files for Masterdrives servos

 

A guide to Use Drivemon to Upload/Download .Dnl files for Masterdrives servos

 

 

 

Read through relevant manual thoroughly before working with the Drives.

 

DANGER!

• Commissioning / Maintenance must be performed only by qualified technicians.
• The emergency OFF functions must be fully operational during commissioning. The relevant safety regulations must be observed to exclude danger for man and machine.
• Incorrect details can damage the Servo motor!
• A charge may still remain in the DC-link capacitor with hazardous voltages even if the power has been turned off. To avoid personal injury, please ensure that power has turned off before operating AC drive and wait ten minutes for capacitors to discharge to safe voltage levels.

CAUTION!

• There are highly sensitive MOS components on the printed circuit boards.
• These components are especially sensitive to static electricity. To avoid damage to these components, do not touch these components or the circuit boards with metal objects or your bare hands.
• The motor data identification should normally be performed when the motor is cold.

Working with  Siemens Masterdrives Compact Plus

The Video below will help you understand

•  how  to go Online,
• Upload/Download Servo  files (.Dnl )with Siemens DriveMon 

 Important Note: Read through the drives Manual to be Safe while working with Drives.

Working with Siemens Starter 4.3 for Sinamics G120 drives (Basic Commissioning)

Working  with Siemens Starter 4.3 for Sinamics G120 drives (Basic Commissioning)

Read through relevant manual thoroughly before working with the Drives.

DANGER!

• Commissioning / Maintenance must be performed only by qualified technicians.
• The emergency OFF functions must be fully operational during commissioning. The relevant safety regulations must be observed to exclude danger for man and machine.
• Incorrect details for the rated current or the maximum current can damage the motor!
A charge may still remain in the DC-link capacitor with hazardous voltages even if the power has been turned off. To avoid personal injury, please ensure that power has turned off before operating AC drive and wait ten minutes for capacitors to discharge to safe voltage levels.

CAUTION!

• There are highly sensitive MOS components on the printed circuit boards.
• These components are especially sensitive to static electricity. To avoid damage to these components, do not touch these components or the circuit boards with metal objects or your bare hands.
• The motor data identification should normally be performed when the motor is cold.

Important Note: Ensure that the IOP Connected  is of correct Firmware Prior Starting  Commissioning.

The Video below will guide you to configure the Sinamics G120 Drives with Siemens Starter

Software Version 4.3.

Please bear with the resolution of the Video as The recorder & Moviemaker doesnt work well together.

Read through the drives Manual to be Safe while working with Drives.

Sinamics G120 USB Bridge Driver

My Experiences With Sinamics G120 -
Starter Version 4.1

I was trying to connect my pc to a Sinamics G120 with CU230P-2HVAC control unit using starter 4.1  and then I faced few problems as indicated .

1.  Drive  Starter Scout- PC COM Port USS  was not available.

2.No COM port available for Communication as shown below.

3. The Third issue was PC-Com Port USS missing in the Install Remove Interfaces Tab  as indicated below. Open the Tab & Click Select button to see .  

 

After several queries & trials I was able to fix this issue using the Driver file attached below.

Use this Zip file -Driver File .

The issue was resolved after trying the above.

Aafter Installing close the Starter Re-open to be cautious & try the steps as indicated above.

Note this is Applicable only for Starter Version 4.1.  as the successive versions use S7-USB drivers.

Hopefully it should work & all the best Folks.